![]() This prompt tells you that you are in global configuration mode. Once you type configure terminalfrom privileged mode, your prompt changes to the following: The file that is copied into NVRAM is called startup-config and is the configuration that is copied to RAM when the router is rebooted or powered up. You can save the running-config to what is called Non-Violate RAM (NVRAM). This allows you to change the running-config, a file that is in DRAM and is the configuration the router is using. However, I prefer to type the shortcut command config t. You make changes by typing the command configure terminal. Once you are in privileged mode, you enter global configuration mode to change the configuration. When you are in privileged mode, the prompt changes to a pound sign (#). The prompt at user mode is the greater-than sign (>). This prompt is asking for the console user-mode password. Line con 0 now ready, press return to continueĪt this point, you press Enter. Here is an example of how to get into privileged mode on a Cisco router through the console port: ![]() The console, aux, and VTY ports are used to get into user mode only and have nothing to do with how the router is configured. It is important to remember that to change the router configuration, you must be in privileged EXEC mode. You can enter privileged mode by first entering user mode and then typing the command enable. The privileged EXEC mode allows full access to a Cisco router by default, and the configuration can be both viewed and changed in this EXEC mode. To view and change the configuration, you need to be in privileged mode. The most important thing to understand about the three connection modes is that they get you into user mode only. You must have an active interface on the router for Telnet to connect to the router.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |